The WTF 36 x 48 Laydown Panel allows a contractor to lay the form either direction. This form is not designed to be put on the bottom of stacked forms.
   

 

Distributors

Sitemap

 


LAYDOWN

Forms

WTF manufactures forms with tie slots for laydown applications. This eliminates the need for special laydown ties or hardware. Often times contractor find the need to lay their forms down to pour 3 ft. tall walls. This application can be achieve two different ways, laydown forms, laydown ties or hardware.


 

 

 

For customers who do not own laydown forms, the following ties and hardware are designed to accomplish laydown applications with standard forms.

Flat Steel U-Tie
  
Wire Base Tie

For laydown applications ONLY! Not to be used in close trench conditions where stripping requires pulling top of form down toward ground. No pins or wedges required.

Maximum wall height: 36"
Maximum tie spacing: 24"

  


Wire base ties are used in laydown form applications. Drive wedges through raised loops to secure base tie through rail.


Base Tie Pin
(Silver Bullet)
  

Flathead Pin

 

For laydown applications ONLY! Base tie pins hold tie in place at the base of the form.

Maximum wall height: 36"
Maximum tie spacing: 24"

  

The flathead pin is used in laydown applications with standard ties. Can also be used when pouring a concrete wall against an existing structure. This pin is the only design used in laydown applications in walls over 36" tall.

Top