Distributors

Sitemap

 


SPECIALTY WALL TIES

Reusable Aluminum
Bar Ties
  Reusable aluminum bar ties are
  used as bulkhead bars as well
  as top spreaders for laydown   applications. May be used with
  the standard pin and wedge.
  These can be used as brickledge   
  bars to nail wooden brickledge
  to top of forms.
Reusable Pull Tie

Designed without rod notches and break-offs so they can be easily removed from a wall and   reused. This is designed for markets with very low labor costs.

Maximum tie size is 8"

Specify Nominal or Full

Tie Sleeve
  

The tie sleeve is used with the reusable pull tie. This sleeve allows for tie removal.
3/8" x 1 ½" x wall thickness to 12"
Single or Combination
2" x 2" x 3/8" x wall thickness
greater than 12"
Specify Nominal or Full and Length

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Concrete Housing Ties
Internal Housing Ties
The internal housing tie is used in conjunction with the WTF Housing System. This tie has a 5/16" breakback on both sides of the tie.

Once the tie is broken using the WTF tie breaker bar, the breakback allows plaster to be applied directly to the concrete without the tie interfering in the plaster process.
Product #TTSP0400002101
  
External Housing Ties
The external housing tie is used in conjunction with the WTF Housing System. This tie has two different breakback points. The first breakback is 2". This is designed for use with the WTF foam and tie retainer. Once the concrete has been placed the tie is broken using the WTF tie breaker. This tie breaks 2" into the wall and solves any thermal bridging that can occur with steel in the concrete wall. The second breakback is 5/16". This is designed to be used on the internal side of the external wall. This breakback allows plaster to be applied to the interior of the wall without tie interference.
Product #TTSP0600002104

 


Flat Steel U-Tie
Wire Base Tie
Maximum wall height: 36"
Maximum tie spacing: 24"

Up to 36" ~
Specify Nominal
Or Full













Up to 20" ~ Specify Nominal or Full


Wire base ties are used in laydown form applications. Drive wedges through raised loops to secure base tie through rail.

Maximum wall height: 36"

Maximum tie spacing: 24"

For laydown applications ONLY! Not to be used in close trench conditions where stripping requires pulling top of form down toward ground. No pins or wedges required.

   

LAYDOWN APPLICATIONS

 

 

 

 

 

 

 

 

 

 

Base Tie Pin
(Silver Bullet)
  

Flathead Pin

 

For laydown applications ONLY! Base tie pins hold tie in place at the base of the form.

Maximum wall height: 36"
Maximum tie spacing: 24"

  

The flathead pin is used in laydown applications with standard ties. Can also be used when pouring a concrete wall against an existing structure. This pin is the only design used in laydown applications in walls over 36" tall.

 

Top