Distributors

Sitemap

 


ATTACHED HARDWARE

Factory installed permanent pin system. When forms are outfitted with attached hardware, wedging is only required at top and bottom pin.


Available on 36" to 9" fillers, however, most
contractors typically
have it installed on
36" wide forms only.

Long Away

Long away pins are used on top and bottom pinholes of form where rod must pass through vertical braces. Can be retracted and loose pins used.
Available for panels 36" - 16" wide
Product #SPI50000000000


Short Away
Short away pins are used on all holes except top and bottom holes on 36" - 16" wide panels. Can be retracted and loose pins used.

Product #SPI51000000000


Short Against
The short against pin is popular among contractors using 9' forms. Pins are attached at the top hole where tie placement is not necessary for alignment. Short against pins are also used on fillers 15" - 9" wide. These pins cannot be retracted in order to use loose pins.
Product #SPI52000000000


On 108" forms, most contractors do not utilize the top hole for a tie, therefore, many choose to place an attached pin which will aid in alignment - by simply engaging the pin.

Top